Tubes made of polypropylene
Caps made of polyethylene
Designed for the simple and safe processing of medium-sized sample volumes. Up until now, for samples larger than 2.0 ml, the only choice was to use large conical screw-cap tubes (15 ml for example) which were both impractical and prone to contamination.
The potential pipettor shaft contamination is greatly reduced since the 62.5 mm total tube length (vs. 120 mm for 15 ml tubes) is short enough for standard 1 ml or 5 ml tips to reach the tubes's conical bottom
The 16 mm tube diameter is identical to the diameter of standard 15 ml tubes, ensuring further compatibility with centrifuge rotors, etc.
Smooth bottom has no sharp points hurting your fingers. Ultra clear resin gives you a better view. Slim design fits high capacity rotors.
3/4 turn leak proof Lip seal caps
Precise lid sealing for minimal evaporation rate during long-term storage.
Withstands temperatures from -196°C to +121°C (not to be immersed in LN2 liquid phase).
Use CapInsert™ M957 for sample identification. Writing surface on flat cap and side wall.
3/4 turn leak proof Lip seal cap available either pre-attached or separately.
Product # | Description | Qty/Pk | Qty/Cs |
T365-5TN | 5ml tube only, Natural | 100 | 200 |
T365-5TAM | 5ml tube only, Amber | 100 | 200 |
T365-5NLSS | 5ml tube and cap, Natural, Sterile | 20 | 200 |
T365-5AMLSS | 5ml tube and cap, Amber, Sterile | 20 | 200 |
T366xLS | Cap only for the 5ml tube | 100 | 200 |